[QUOTE=Bill Harsey;241279]The toughest folds to get right are the last two so I have a paper master pattern to indicate in the folding points then make the folds holding the steel machinists rule over the line.
Use the hand roller to crease the fold better. The roller is usually for doing the seams on the stainless steel foil heat treat packages that knives go inside of when in the oven.
Then I re-sharpen an Exacto knife blade to make it a more acute edge than it comes from the factory and do the cutting on some Kydex left over from sheath making. A new Exacto blade would work just fine but use the larger handle for control.QUOTE]
I can only imagine the detail you put into your blades.
