Quote:
Originally Posted by 82ndtrooper
I have the MI "Omega" 7" rail system on an old Bushmaster "Trunk Gun"
No gunsmith required, Free Float, and has 1" rail to cover the delta ring assembly making it an uninterupted rail system on the your top rail.
|
just wanted to point out that the Omega rail is made by daniel defense, not MI:
http://www.danieldefense.com/?page=s...tems_omegarail
I've a couple of MI rails and they fit all mil-spec accessories. quality is good and they're reasonably priced, but the handguard tend to be a bit wider than others.
edited to add: on the MI freefloat rail, it does have the cutouts for the KAC panels. however, on the rear one, the clamping system prevents the KAC panel from going back far enough for the latch to engage the cutouts, which should have been moved forward a notch. i told them about this but am not aware if it has been corrected. i did a writeup back in '06 with some pics (username and password are both 'mm' to view larger pics):
http://www.militarymorons.com/weapon...ppers.html#mwi